Filter
Top Products
REMOTEAOMlN&MAlNTPROCEOURES
SECTION 200-096-600
FEBRUARY1991
TABLERM-L
PROGRAM04
PORT/STATIONNUMBERASSlGNMENT
;TEP
ACTION
DISPLAY/PRINTOUT
1
Enter the Program Mode
>MODE PROG
At the >MODE prompt enter i m @ H
q
P
2 Enter Program Number 04
P 04
Press
q
. PO4
3
Enter the Port Number
PO4
Refer to the System Record Sheet and enter the desired
PO4 01
port number.
Example: Port number 01, enter a 0.
4
Press 1 key.
PO4
System displays present station number. Refer to the
PO4 Ol# 201 206
System Record Sheet and enter the desired station number.
Example: Station number 206, enter 1 1 1.
5
To Exit Program/Store Data
PO4
A) To store data; press
q
PO4 ##
B) Continue returning to step 3 until all
Program 04
P
data is entered.
C) To exit this program, press fl 1 [9 .
NOTE:
A blank is displayed by ‘N”.
TABLERM-M
PROGRAM05
FLEXIBLEACCESSCOOENUMBERING
iTEP ACTION
DISPLAY/PRINTOUT
1
Enter the Program Mode
>MODE PROG
At the >MODE prompt, enter i 0 u H
q
.
2
Enter Program Number 05
P 05
Press
q
PO5
3 Enter Access Code number that you wish to change (0 - 9)
PO5 4 4
Example: 4 (if it was not previously changed, the system
will print another 4. If it has been previously changed,
the system will print the number to which it was changed).
4 Change the number if required (one or two digits)
PO5 4 4 6
Example: Change to 6, press
q
5
Continue returning to step 3 until all required access
codeshavebeenchanged.
6
To Exit this Program
P
Press 1 1
q
.
,
NOTE:
Program 10,
use Type I procedure.
-2o-