Filter
Top Products
REMOTEADMIN &MAlNTPROCEDURES
SECTlON200-096-600
FEBRUARY1991
TABLERM-AT
PROGRAM52
LCROFFlCECODEEXCEPTlONSFORSPEClFlEDAREACODE
iTEP ACTION
DISPLAY/PRINTOUT
1
Enter Program Mode
>MODE PROG
At the >MODE prompt, enter B 0 m a
q
.
P
2 Enter Program Number 52
P 52
Pressm .
P52
3 Define Route Plan Number
P52 10 0 3
Refer to the System Record Sheet and enter the
L LCR Plan No.
exception table number (1 m 8).
!-
L
Example: Table 1, enter 8.
Action Code
Enter Action code 1 .
Exception Table No.
The system will print out the currently defined route
plan number. Refer to the System Record Sheet and
enter
new plan number if required. Example: Change to 3.
4 Define Area Code Number
Press [9 .
P52 ll~tl~212
P52
Enter exception table number (1 - 8) defined in step 3.
Enter Action code 0
The system will print out the currently defined area
--iI
k
Area Code
Action Code
Exception Table No.
code number. Refer to the System Record Sheet and enter the
new area code number if required.
Example: Change to 212, enter 1 0
Press
q
.
1.
5 Display Office Codes
P52 14
Enter exception table number defined in step 3.
Enter Action code 1 .
Press m to dis la
ooooodOOO
5s
previously selected office codes.
Continually press
l
’ until all previously selected
T
Office Codes
codes have been displayed, then press
q
.
6
To Add 2) or Delete (3) Office Codes
d
P52 12
Press - .
300-325
Enter exception table number defined in step 3.
P52
Refer to the System Record Sheets and enter 1
to add office codes or 1 to delete office codes.
Example: Add office codes 300-325
Enter 1 (OrI )1111111m
7
To Exit Program/Store Data
Data was stored when
q
was pressed in step 6.
P52
# #
A)
P
B) Continue returning to step 3 until all data is entered
for this program.
-43-