Filter
Top Products
MESSAGE SENDING
(continued)
MESSAGE SENDING
(continued)
TO SET A MESSAGE IF YOU DO NOT HAVE Am BUTTON
1) Press the m button.
l
The INT LED liahts.
2) DialBI. y
3) Dial the number of the message you want (see Note).
4) Press the m button.
l
The INT LED goes out (your message is now stored).
NOTE:
Personal (10 - 19) and system (60 - 99).
TO CANCEL A MESSAGE THAT HAS BEEN SET AT YOUR
STATION
Press the m button.
l
The MSG LED goes out.
TO CANCEL A MESSAGE IF YOU DO NOT HAVE A m
BUlTON
1) Press the m button.
l
The INT LED liahts.
”
2) Dial 11.
3) Press the m button.
l
The INT LED goes out.
NOTE:
A personal message (10 - 19) will remain stored in memory.
BUSY STATION MESSAGING
When reaching a busy LCD station, a message can be sent to that
station (an audible tone will be heard). The busy station may also
return a message to the calling station’s LCD. The two stations may
continue this procedure to carry on a “silent” conversation.
2) Press the m button.
l
The LCD displays, MODE NO.?
3) Dial 1.
l
The LCD displays, OVER TO STNN MSG NO?
4) Enter the desired message number.*
l
The LCD displays the message.
5) Press them button.
l
The LCD displays, MSG SEND.
6) The destination station beeps four times and the message is
displayed for 30 seconds, or until originating station hangs up.
*Personal (10 - 19) and system (60 - 99).
TO RETURN A MESSAGE (Within 30 Seconds) FROM THE
BUSY STATION AFTER RECEIVING A “BUSY STATION”
MESSAGE.
1) Press the m button.
l
The LCD displays, MODE NO?
2) Dial 1.
l
The LCD displays, OVER TO STNN MSG NO?
3) Enter the desired message number.*
l
The LCD displays the message.
4) Press the m button.
l
The LCD displays, MSG SEND.
TO SEND A MESSAGE TO A BUSY STATION
1) Call the desired station.
l
Listen for busy tone.
30
31