Filter
Top Products
REMOTEADMlN&MAlNTPROCEDURES
SECTION 200-096-600
FEBRUARY1991
TABLERM-BJ
CO LINETEST
STEP ACTION
DISPLAY/PRINTOUT
1
Enter the Test Mode
>MODE TEST
At the >MODE prompt, enter 1 B 1 0
q
.
2
To Verify Station/CO Line Status
T SEKT XX IDLE ON-HOOK
~~'ip,n,'~~t~~'~~;,~r~~ 11’ ‘(1 f _O,&?ZZ~~~~r).
9 SC0
yy
IDLE
3
Call Remote Station B
(from SEKT XX and CO line YY)
Enter I[3 1113 1 i ~~~iJOOO[9.
T ‘I-K xx KYY~~~[7tlfl~
T
(0 = station B’s telephone number)
Answer station B.
NOTE:
If the system is equipped with MOH, go to step 4.
If the line must
be tested via a CO-to-CO connection, go to step 6.
4 A) Press the
T TKXX H
Enter 1
m
0 D key on TK XX (station B on hold).
QEI.
T
B) Listen at station B and check that the transmission from the
music source is acceptable.
C) Press the
l
D
Enter 0
m
key on TKXX (to release the call).
T TKXX S
ma
T
5 Continue returning to step 2 until all CO lines are tested.
6
To Set Up A CO-to-CO Connection
T TKXX C
Press the m key on 0 [3 1 1
T
Enter 0 1 1 1 1 q
NOTES:
1. Station B is connected via step 3.
2. Verify that Program 15-5 allows CO-to-CO connections.
3. The next step must be completed immediate/y to avoid
dial tone timeout.
7 Call station C (or local time/weather) via CO line C.
Enter: 0 [3 1111 i oooooC!Eia
T ‘JXXX KYYOOOnOnn
T
1 1 = CO line C’s key number and [7 = telephone number of
station C.
Answer station C (or verify time/weather connection) and go to
next step.
8 Press the m key on STXX to establish a conference
TTKXXC
between all parties. T
9 If you wish to tie the two CO lines together and hang up: TTKXXC
Enter 0 [3 0 1 m q .
TTKXX S
Enter 0 [3 1 1 B q .
T
10 Continue returning to step 2 until all CO lines are tested.
11
To Exit the Test Mode,
.
At the T prompt, enter m m 0 0
q
.
-57-