Filter
Top Products
INSTALLATION-PCB
SECTION 200-096-206
FEBRUARY1991
TABLE6-H
PlOUSCONTROLSANOlNTERFACECONNECTORS
CONTROL/INDICATOR/
CONNECTOR
(Figure 6-11)
TYPE OF COMPONENT DESCRIPTION
SMDRTTY Interface
Connector J3
Dual modular connector
Interface connector for SMDR printer/
call accounting device and
maintenance terminal/modem.
IMDU Connector PI
1 O-pin connector
Interface connector for Remote
Maintenance Modem piggy-back module.
IMDU Connector P2
g-pin connector
Interface connector for Remote
Maintenance Modem piggy-back module.
IMDU Connector P3
3-pin connector
Interface connector for Remote
Maintenance Modem piggy-back module.
M/B Make/Break Jumper
External Page/Door Lock Control Relay
WI
Wire jumper
MAKE or BREAK jumper.
M/B Make/Break Jumper
Night/Hold Relay MAKE or BREAK
w2
Wire jumper
jumper.
_
Alarm Sensor N.O./N.C.
Alarm sensor normally open or normally
w3
Wire jumper
closed jumper.
CCITT/BELL Jumper
w4*
Wire jumper
IMDU or external modem operating spec-
ification jumper plug. (BELL = NO W4)
SMDR Baud Rate
Switch SW1
TTY Baud Rate Switch
SW2
Two-position slide switch
Selects baud rate (300 or 1200 bps) for
SMDR printer or call accounting device.
Two-position locking push-
Selects baud rate (300 or 1200 bps) for
button switch
Remote Maintenance Modem piggy-back
module (IMDU) or external TTY jack.
Modem/TTY Switch
SW3
Two-position slide switch
Enables PIOUS for operation with IMDU
modem or TTY jack.
*Most modems in USA require BELL specification: W4 not factory-installed.
scribed in Table 6-G. PIOUS information is pro-
vided in Figure 6-l 1 and Table 6-H.
9.10 PIOU and PIOUS Hardware Options
9.11
The PIOU and PIOUS support the following
hardware options:
Internal Options
l
Remote Maintenance Modem Unit (IMDU)
External Options
l
Built-in Paging Amplifier (PIOU only)
l
Door Lock Control or External Amplifier Control
l
Alarm Sensor
l
External Paging 6OOQ (duplex) Interface
l
Zone Page, 4-zones (PIOU only)
l
Local Maintenance Terminal or Modem
l
Music-on-Hold Control or Night Relay Control
0 SMDR Printer or Call Accounting Port
l
Remote Maintenance Port
NOTE:
Refer to Peripheral Eqyipmen t Ins talla tion,
Section 200-096-208, for installation of exter-
nal options.
6-22