Filter
Top Products
PROGRAMMlNGPROCEOURES-INSTRUCTIONS/SYSTEMRECORDS
SECTION 200-096-302
FEBRUARY1991
PROGRAMlO-
SYSTEMASSIGNMENTS,PARTl OF2
~~-~~~~~-~~-~~~~-~~-T;1
7
\
SELECT = 7
Key LEDs
Light LEDs as described
in the table below
NOTES:
1. For more information, see the instructions preceding the record sheets.
2. Initialized data lights LEDs 07, 08, 09, 18, 19 and 20.
3. LED 04 DTMF Signal Time applies to manual and speed dial tones sent out of the system via CO or TIE lines. LED 04 does
not apply to Call Forward or Voice Mail ID DTMF tones sent to voice mail ports. (See Program 10-2, LED 06, for tones sent
to Voice Mail ports.)
4. If ring transfer is allowed, set Ring Transfer Recall time in Program 37; if ring transfer is not allowed (LED 07 off), the station
will recall immediately if transfer is attempted.
5. Standard ring pattern is 1 sec. on, 3 sec. off.
6. Release 1 software detects short ring signals only.
7. Two CO conference must be allowed for DISA operation.
8. CO line guard time is the time interval the system requires to release a CO line and allow it to be re-seized. If LED 02 is off, all
lines are set with 0.45 second guard time: if LED is on, guard time is 0.45 or 1.5 seconds per Program 42-O.
2-53