Filter
Top Products
REMOTEAOMIN &MAlNTPROCEDURES
SECTlON200-096-600
FEBRUARY1991
TABLERM-AA
PROGRAM78
CO LINESPECIAL RINGING ASSIGNMENTS-DISA/IMDU/NIGHTRlNGlNG OVER EXTERNAL-PAGE
;TEP
ACTION
DISPLAY/PRINTOUT
1 Enter Program Mode
>MODE PROG
At the >MODE prompt, enter i 0 m H
q
. P
2 Enter Program Number 78
P 78
Press
q
. P78
3
Refer to the System Record Sheet and enter the feature number
P78 1
for the feature to be programmed.
Example: Feature code 1, enter 0 .
4 Refer to the System Record Sheet and enter the code number P78 13
for the area of the feature being programmed.
Example: Code 3, enter 1
5 Refer to the System Record Sheet and enter the CO line keys that ~78 13 01 N
will be associated with this feature. 02 N Y
Example: CO key 01, enter 1 1.
The system will designate whether the CO key/LED is on/off.
Refer to the System Record Sheet and change if required.
Press= to display next CO key/LED.
6
To Exit Program/Store Data
P78 13 01 N
A) To store data, press [9 .
02 N Y
B) Continue returning to step 3 until all data has been entered
P78 ##
for this program. P
C) To exit this program, press 1 1
q
NOTE:
Program 79 uses Type 2 procedure.
-31-