Filter
Top Products
the procedure for entering and leaving programming mode depends on
the type of voice terminal you are using, be sure that you follow the
general programming directions carefully.
● How To Use Step-by-step procedures are provided for using each feature.
General instructions for entering and leaving administration and
programming mode appear below.
Only the specific steps for a particular
procedure appear in each feature entry.
Programming, administration, and
using information are provided only when applicable.
General Procedures for Administration and Programming
To perform system administration or to program a voice terminal, you must
take the administrator/attendant console or the voice terminal out of regular
call-handling mode. The console or voice terminal can’t be used to place or
receive calls while in administration or programming mode.
The procedures for putting the administrator/attendant console into and out
of administration mode and for putting a voice terminal into and out of
programming mode appear below.
NOTE: The planning forms for the system show line and feature
assignments.
If you are administering a new feature, keep the
appropriate planning form handy as a guide. If you’re changing an
existing feature, be sure to change the form as well.
ENTERING AND LEAVING
If you have a MERLIN II System Display Console, you place an overlay on
ADMINISTRATION MODE
the console when you are performing administration. This overlay, packaged
with the console, shows the functions of the buttons when the console is in
administration mode.
NOTE: The overlay may have been placed in the specially-made
labeled pocket folder of the MERLIN II lnstallation and Administration
Manual when the system was unpacked and installed.
Place the overlay on the console before you enter administration mode and
remove it when you leave administration mode.
To enter administration mode:
1
2
To
1
Slide the T/P switch to P.
Touch Conference twice.
If you‘re using a MERLIN II System Display Console, the administration menu appears.
you‘re using a BIS-34D Console, lights flash next to Adm Pool, Adm Tel, Message,
and Speaker.
leave administration mode:
Slide the T/P switch to the center position.
If
MERLIN II System Features 2-3