Filter
Top Products
ADMINISTRATION
Before you begin, be sure your system is set for square configuration. See
“System Type. ”
Have the Station Configuration Forms handy. To assign
lines to buttons in a square system, enter administration mode and follow the
appropriate procedure below.
With a MERLIN II System Display Console
1 From the administration menu, touch these buttons:
[Stations], [Line/Pool] .
2 Touch the Auto Intercom button for the voice terminal.
3 Touch
[Enter].
NOTE: If the voice terminal is being used, the message, “station busy -
please wait, ”
shows on your display. You must either wait until the
station becomes available or try again later.
4 Touch the line buttons until the correct code shows:
Green light on =
line is assigned to the voice terminal
Green light off = line is not assigned to the voice terminal
If you want to give another voice terminal the same line assignments as
one you have already set up, use the following shortcut:
NOTE: Be aware that when you copy line assignments, you also copy
call restrictions and allowed-list permissions. Be sure you want the two
voice terminals to be identical in these respects before using this Copy
procedure.
a Touch
[Copy] .
b In response to the prompt, touch the Auto Intercom button of the
station you are copying from.
C Touch [Enter] .
d In response to the prompt, touch the Auto Intercom button of the
station you are copying to.
e Touch
[Enter] .
You hear a 2-beep signal to let you know that the copy procedure is complete.
f Repeat steps b through e for each voice terminal for which you want to
copy line assignments.
g Touch [Exit] to return to the Stations screen.
5 To make line assignments to a different voice terminal, repeat steps 2
through 4.
6 Touch Conference to return to the administration
administration mode.
With a BIS-34D Console
1 Touch Adm Tel.
menu, or leave
2 Touch the Auto Intercom button for the voice terminal to which you want
to assign lines.
A steady green light comes on next to the voice terminal’s Auto Intercom button. The
system gives a 2-beep signal for you to begin.
2-102 MERLIN II System Features