Filter
Top Products
3
4
5
NOTE: If the light next to Adm Tel flashes, you can’t perform this
procedure now. Take one of these actions:
Wait for the light to become steady, then go to step 3.
Leave administration mode and try this procedure again later.
Refer to the Station Configuration Form to see which line pools or
individual lines should be assigned to buttons on this voice terminal.
Steady green lights show next to any lines now assigned to the voice
terminal, either as individual lines or as part of a line pool. Steady red
lights show next to all lines contained in any system pool.
Touch the button for any line pool or line you want to add to or remove
from this voice terminal. Each touch of the line button gives you one of
the following codes:
Green light on
= line is assigned to the voice terminal
Gwen light off = line isn‘t assigned to the voice terminal
NOTE:
Lines in a line pool always change as a group. When you touch
the button for any line in a line pool, you change the status of all the lines
in that line pool.
Repeat steps 2 through 4 or use the Copy procedure, below, for each voice
terminal in your system.
If you want to give a voice terminal the same line pool and line assignments
as one that’s already set up, use this shortcut:
NOTE: When you copy line assignments, you also copy any call
restrictions, Dial Access to Line Pools, and allowed-list permissions
assigned to the original voice terminal. Be sure you want the two
voice terminals to be identical in these respects before using this Copy
Procedure.
a Touch
b Touch
The red
c Touch
the Auto Intercom button of the
Recall.
light next to Adm Tel flashes.
the Auto Intercom button of the
new voice terminal.
original voice terminal.
When the copy procedure is complete, the red light stops flashing.
d Repeat steps a through c for each voice terminal for which you want to
copy line pool and line assignments.
6 Touch Adm Tel and go on to another procedure, or leave administration
mode.
Assigning Dial Access to Line
have already set the system for
Type. ”
Pools Before you begin,
Dial Access to Line Pools.
be sure that you
See “System
To assign voice terminals Dial Access to particular line pools, enter
administration mode and follow the procedure below.
1 Touch Adm Tel.
2 Touch the Auto Intercom button for the voice terminal to which you want
to assign Dial Access to selected line pools.
If the voice terminal is idle, a steady green light goes on next to its Auto intercom button,
and the system gives you a 2-beep signal to begin.
MERLIN II System Features
2-97