Filter
Top Products
Administration Procedure
Camp On:
To set the Camp On return interval
Centralized Programming
Dialing Timeout for rotary lines
Direct Inward System Access
Do This
1 Reach screen via
[More], [Options] [CampOn] .
2 Enter the number of minutes (1 through 5) that calls should
camped.
3 Touch
[Enter] .
4 Touch Conference to return to the administration menu.
remain
1 Reach screen via [More], [More], [Cntr-Prg].
2 Touch Auto Intercom button for voice terminal to be programmed.
3 Touch
[Enter] .
4 If red light next to Adm Tel goes off and console rings every
5 seconds, go on to step 5. If not, wait for light to go off or try
again later.
5 perform programming steps, except for entering and leaving
programming mode.
6 Touch Conference to return to the administration menu.
1 Reach screen via
[More], [Options], [More], [More], [Rotary] .
2 Dial number to specify timeout interval:
0 = 0 seconds
1
= 4 seconds
2 = 8 seconds
3 = 12 seconds
3 Touch Conference to return to the administration menu.
1
Reach screen via [Lines], [DISA] .
2 Dial a four digit password, or touch Drop to remove entry.
3
Touch [Enter] .
4 Touch [NoRestr] for no restriction, or touch [InwdOnly] for
inward only.
5 Touch line button:
Green light on
= line or line pool can be used for DISA
Green light off =
line or line pool cannot be used for DISA
6 Touch Conference to return to the administration menu.
.
.
.
3-32 Menu-Driven Administration Procedures