Filter
Top Products
Touch-Tone or Rotary Signaling
DESCRIPTION
When the MERLIN II system is installed, it is set to send or generate Touch-
Tone signals.
If some of the system’s lines generate rotary pulses, you need
to identify each of those lines to the system,
If you are not sure whether lines are Touch-Tone m rotary, perform this test
at the administrator/attendant console:
1 Make sure the T/P switch is in the center position.
2 Touch each line button and dial out.
If
the line is Touch-Tone, you hear tones and the dial tone stops. If the line is rotary, you
hear tones, but the dial tone is not interrupted.
ADMINISTRATION If there are rotary lines in the system, enter administration mode and follow
the appropriate procedure below to identify them.
With a MERLIN II System Display Console
1 From the administration menu, touch
[Lines], [More], [TchTone] .
2 Touch each line button until the light next to it shows the appropriate
code:
Steady green on = Touch-Tone
Green
off = rotary
3 Touch Conference to return to the administration menu, or leave
administration mode.
With a BIS-34D Console
1 Touch Message.
2 Dial # 302.
3 Touch each line button until the light next to it shows the appropriate
code:
Green light on = Touch-Tone dialing
Green light off = rotary dialing
4 Touch Message and go on to another procedure, or leave administration
mode.
2-160 MERLIN II System Features