Filter
Top Products
HOW TO USE
2 Dial *25.
3 Program another feature, or leave programming mode.
1 Place a ringing intercom call.
2 If you hear a busy signal or the person doesn’t answer touch Barge-In.
If a call is in progress, the people hear a tone, then
you
are bridged onto their call, If Do
Not Disturb is in effect, the person you are calling hears ringing.
Attendant Postion Setting
DESCRIPTION
The system administrator must identify the stations that will be attendant
positions.
CONSIDERATIONS
ADMINISTRATION
●
●
●
●
The system always recognizes the console that is plugged into default
station jack 01 (intercom 10) as an attendant position.
Every fourth analog station jack can be used for an attendant position and
no more than two stations on a single analog voice terminal module can
be designated as attendant positions.
A MERLIN II system can have a maximum of eight attendants.
If the administrator changes a standard voice terminal to an attendant
position or voice versa, he or she must reassign lines and features to the
voice terminal or console.
Get the Master Planning Form or the Station Configuration Forms, which
show the stations to be used as attendant positions. Enter administration
mode, and follow the appropriate procedure, below, to designate attendant
positions.
With a MERLIN II System Display Console
1 From the administration menu, touch these buttons: [System], [Attendants],
[Position].
A steady or a flashing green light will appear next to each button for each station that
either is or can be an attendant position (see Step 2 below). No light goes on next to the
button for a station that cannot be an attendant position.
NOTE: If you see the message, “System busy—please wait, ” wait for a
prompt or try this procedure again later.
2 To change an attendant position setting, touch the Auto Intercom button
for the station until the green light next to the button shows the setting
you want:
Green
light on
=
this station is an attendant position.
Green light flashing
=
this station can be but is not now an attendant position.
3
Touch [Store] .
You see
the message,“System is Re-starting” and then the administration menu reappears.
MERLIN II System Features 2-9