Filter
Top Products
Administration Procedure
Do This
Call restrictions and allowed lists
1 Touch Message.
continued):
2 Dial #4.
To assign access to allowed lists to
3 Dial list number (0 through 7).
voice terminals
4
Touch Auto Intercom button for voice terminal:
Steady green on
= voice
terminal has access to numbers on list
Green off = voice terminal doesn‘t have access to numbers on list
5 Touch Message.
To get a printout of an allowed list
1 Touch Message.
2 Dial #5.
3 Dial list number (0 through 7).
4 Dial 0 #900 and wait for beep.
5 Touch Message.
To get a printout of voice terminal
1 Touch Message.
access to allowed lists
2 Dial #904 and wait for beep.
3 Touch Message.
Camp On return interval
1 Touch Message.
2 Dial # 326.
3
Dial number of minutes (1 through 5) preferred before calls
return to originator.
4 Touch Message.
Centralized Programming
1 Touch Conference.
2
Touch Auto Intercom button for voice terminal to be programmed.
3
If red light next to
Adm Tel
goes off and console rings every 5
seconds, go on to step 4. If not, wait for light to go off or try
again later.
4
Perform programming steps, except for entering and leaving
programming mode.
5 Touch Conference twice.
Dialing Timeout for rotary lines
1 Touch Message.
2 Dial # 317.
3
Dial number to specify timeout interval:
0 = 0 seconds
1 = 4 seconds
2 = 8 seconds
3 = 12 seconds
4 Touch Message.
3-10 Button Code Administration Procedures