Filter
Top Products
Administration Procedure
Call restrictions and allowed lists:
To assign outward and toll call
restrictions to voice terminals:
NOTE:
If you
do not
need to dial a toll
prefix (0 or 1) to place a long distance
call, perform steps 1 and 2 below. If
you use a toll prefix, just perform
step 2 below.
1 To set lines to identify long
distance calls by area code only
2
To assign call restrictions to voice
terminals
To copy line assignments and call
restriction assignments from one voice
terminal to another
To set up allowed lists
Do This
1
2
3
1
2
3
4
5
6
1
2
3
4
5
6
1
2
3
4
5
6
Touch Speaker.
Touch line buttons:
Steady green on
= toll calls detected by toll prefix only
Green off =
toll calls detected by area code or toll prefix
Touch Speaker.
Touch
Adm Tel.
Touch Auto Intercom button for voice terminal.
If steady green light shows next to
Adm Tel
and you hear two
beeps, go on to step 4. If not, wait for 2-beep signal or try
again later,
Touch Speaker.
Steady green on = all calls permitted (unrestricted)
Flashing
green =
local and intercom calls and calls to numbers on
assigned lists permitted (toll call restriction)
Green off = intercom calls and calls to numbers on assigned lists
permitted (outward call restriction)
Touch Speaker.
Touch
Adm Tel.
Touch
Adm Tel.
Touch Auto Intercom button for new voice terminal.
If a steady green light goes on next to the Auto Intercom button and
you hear two beeps, go on to step 4. If not, wait for 2-beep signal
or try again later.
Touch Recall.
Touch Auto Intercom button for voice terminal whose assignments
you want to copy.
When red light next to
Adm Tel
stops flashing, touch
Adm Tel.
Touch Message.
Dial #5.
Dial list number (0 through 7).
Dial entry number (0 through 9).
Dial entry (area code and/or exchange
or emergency number), or
touch Drop.
Touch Message.
Button Code Administration Procedures 3-9