Filter
Top Products
Administration Procedure
Do This
Touch-Tone or rotary signaling
1 Touch Message.
2 Dial #302.
3 Touch line buttons:
Steady green on = Touch-Tone
Green off= rotary
4 Touch Message.
Voice Terminal Type Setting (raised plastic
1 Touch Message.
or flat membrane button)
2 Dial #320.
3
Touch Auto Intercom button(s):
Green light on
= raised plastic button voice terminal
Green light off = flat membrane button voice terminal
4 Touch Message.
Voice Announcement to Busy Voice
1 Touch Message.
Terminal
2 Dial #210.
3
If green light next to
Message
is steady and you hear two beeps, go
on to step 4.
If not, wait for 2-beep signal or try again later.
4
Touch either of two adjacent Auto Intercom buttons:
Green light on =
station jack part of voice/voice pair
Green light off =
station jack not paired
5 Touch Message.
Voice terminal line assignments in square
1 Touch Adm Tel.
systems and behind switch systems
2
Touch Auto Intercom button for voice terminal.
3
If steady green light shows next to
Adm Tel
and you hear two
beeps, go on to step 4.
If not, wait for 2-beep signal or try again
later.
4 Touch line buttons:
Steady green on =
line assigned to voice terminal
Green off = fine not assigned to voice terminal
5 Touch Adm Tel.
3-4 Button Code Administration Procedures