Filter
Top Products
4 Go on to another procedure, or leave administration mode.
With a BIS-34D Console
1 Touch Message.
2 Dial # 203.
NOTE: If you see the message “Wait: System Busy, ” wait for the prompt
or try this procedure again later.
3 Check the lights next to the Auto Intercom buttons. A green light goes
on next to the button for each station already designated as an
attendant position.
A flashing green light goes on next to the button for
each station that can be used as an attendant position.
No lights go on
next to the buttons for stations that cannot be attendant positions.
4 Touch the Auto Intercom buttons until the green light next to the button
shows the setting you want:
Green
light on
=
this station is an attendant position.
Green light flashing
=
this station can be but is not now an attendant position.
5 Dial #.
6 After several seconds, the lights next to Adm Pool, Adm Tel, Message,
and Speaker begin to flash.
At this signal, go on to another procedure or
leave administration mode.
Auto Answer-All
DESCRIPTION
If you want calls to be answered
answering machine connected to
Auto Answer-All button.
automatically by an optional modem or an
your voice terminal, you need to program an
CONSIDERATIONS
● YOU can have both Auto Answer-All and Auto Answer-Intercom
programmed for your voice terminal; however, the two buttons cannot be
turned on at your voice terminal at the same time.
● If you want an answering machine to answer intercom calls, use the Auto
Answer-All rather than the Auto Answer-Intercom feature. If you try to
use an answering machine with the Auto Answer-Intercom feature, it may
cause intercom calls to be dropped.
● If you want an answering machine to answer only intercom calls, not
outside calls, program all your lines for no ring. (See “Ringing Options.”)
● In order to use a modem or answering machine with your analog voice
terminal, you must have a General Purpose Adapter. (See “General
Purpose Adapter”
under “Accessory Equipment. ” )
● If you have an Hands Free Unit, see “Auto Answer-Intercom, ” below.
2-10 MERLIN II System Features