Filter
Top Products
5
6
7
8
9
jack. This is the first line or station to be renumbered in the string of lines
or stations.
Touch
[Enter] .
The system displays the
lowest-numbered code and prompts you to enter the code for the
last station or line, i.e., the one with the highest-numbered jack.
Touch the Auto Intercom button or line button of the last (highest-
numbered) station or line in the string of lines or stations.
Touch
[Enter] .
The system prompts you to type in the first new Flexible Numbering code.
Type in the first (lowest-numbered) new dial code.
Touch
[Enter] .
I
J
The system renumbers the entire string of stations or lines sequentially, then returns you to
the Block Renumber screen.
10 Continue with Flexible Numbering, touch Conference to return to the
administration menu and administer another feature, or leave
administration mode.
Single Renumbering
To assign a Flexible Numbering code to a particular
group, do the following:
1 From the administration menu, touch
[FlexNum] .
2 Touch [Single] .
NOTE: If you get a “System busy - please wait”
station, line, line pool, or
message, you can’t
perform this procedure right now. Wait for the prompt or try again later.
3 Touch the appropriate key for the type of code you want to change, such
as
[Pools] to assign a new code to a line pool.
4 Take one of the actions below to indicate the “old” dial code. Note that
third method can only be used for lines or stations.
Type in the existing dial code.
Type in the logical ID number.
Be sure to type the pound sign ( # )
before the number.
NOTE: Logical ID numbers run from lowest to highest, with the
lowest numbered code being #1. For example, to specify line pool 9,
you would type “ # 1.”
Pool 890 is #2, Pool 891 is #3, etc.
If you’re identifying a line or station, touch the line button or Auto
Intercom button.
The light next to the line goes on.
2-66 MERLIN II System Features