Filter
Top Products
Special Characters in Programmed Dialing Sequences
Using On-Hook Dialing
1 Without lifting your handset, touch Speaker.
2 Dial the number.
3 When you hear the other person answer, lift your handset to speak.
If the line is busy, or if you get no answer:
1 Touch Speaker to cancel the call.
Using Monitor-on-Hold
1 Touch Speaker.
2 Hang up.
3 When you hear the other person return to the call, lift your handset and
continue the call.
Using Group Listening
1 While a call is in progress, touch Speaker and continue your conversation.
DESCRIPTION
You may need to program a pause, stop, or switchhook flash into an Outside
“-
Auto Dial, a Personal Speed Dial, or a System Speed Dial sequence, or you
may need to switch from rotary to Touch-Tone signals in the middle of a
programmed dialing sequence.
To do so, you must enter special characters
when you program the sequence.
In a behind-switch system, you enter host system codes beginning with the
pound sign ( # ) as described in the documentation for the host system. To
use a MERLIN II system code beginning with the pound sign, you must
program a Speed Dial Access button.
You touch that button instead of
touching #, then dial the digits of the code.
PROGRAMMING
HOW TO USE
To program a Speed Dial Access button, label a button, enter programming
mode and follow these steps:
1 Touch the button you want to program.
2 Dial *20.
3 Program another feature, or leave programming mode.
Use the following procedures to enter special characters into a programmed
dialing sequence.
MERLIN II System Features
2-149