Filter
Top Products
With a BIS-34D Console
To set up line pools and assign line pools and lines to stations, enter
administration mode and follow the appropriate procedure below.
Assigning Lines to Line Pools
1
2
3
4
5
6
Touch Adm Pool.
NOTE: If the green light next to Adm Pool flashes instead of remaining
steady and you don’t hear a 2-beep signal, your lines are in use. You
cannot set
up line pools unless all the voice terminals in your system are idle.
Wait until you hear the 2-beep signal or leave administration mode and try
again later.
When you entered administration mode and touched Adm Pool, the
system put you in the main pool (default pool 9). If you want to
administer any other line pool, you must dial the pool’s access code
(default codes are 890 through 899).
Steady red lights appear beside each line that is assigned to this pool.
Touch the button of any line whose pool assignment you want to change.
Each touch of the button gives you one of the following codes:
Red light on
= line is assigned to the pool
Red light off = line is not assigned to the pool
If you hear a beep when you touch a line button, the line is already in
another pool or assigned to Music-on-Hold or Loudspeaker Page. You
must remove the line from its current pool by dialing that pool’s access
code and touching the line button before you can assign the line to the
pool you are administering.
To administer another pool, dial the appropriate access code and repeat
step 3.
To make sure that your line pools are set up as you want them, dial the
access code of each line pool in turn and verify that the steady red lights
are on next to the correct line buttons.
Touch Adm Pool and go on to another procedure or leave administration
mode.
Assigning Line Pools or Lines to Buttons Follow the procedure below to
assign or remove lines or line pools from voice terminals. If you’re assigning
lines, be sure to touch the buttons in the order in which they appear on the
Station Configuration Form.
It’s advisable to keep line buttons together on a voice terminal. If you
remove a line in the middle of a column of line buttons, it’s best to reassign
the remaining lines so that the lines appear on an unbroken sequence of
buttons.
1 Touch Adm Tel.
2 Touch the Auto Intercom button for the voice
to assign line pools or lines.
A steady green light comes on next to its Auto Intercom
2-beep signal to begin.
terminal to which you want
button. The system gives you a
2-96 MERLIN
II System Features