Filter
Top Products
With a BIS-34D Console
PROGRAMMING
1
2
3
4
5
6
Touch Message.
Dial # 202.
If the
system can be administered, the green light next to Message is steady.
When you hear a 2-beep signal to begin, dial 4.
After several seconds, the lights next to Adm Pool, Adm Tel, Message, and Speaker
begin to /lash.
Touch Message,
You can assign dial codes of up to six digits to the Conference, Drop, and
Transfer buttons to access these features in the host system. To assign
codes:
a Dial #328.
b Touch Conference, Drop, or Transfer.
c To assign a host system access code to the button, dial the appropriate
code (up to 6 characters, including O through 9, *, #, Hold [pause],
and Recall). If you don’t dial a code, the button keeps the default
feature, Recall.
Touch Message and go on to another procedure, or leave administration
mode.
In systems set for behind-switch operation, you can program buttons that let
you:
● Use dial codes to access features while you’re on a call
● Use the MERLIN II system Conference, Transfer, and Drop features
instead of the equivalent features of the host system
Speed Dial Access Button
To program a Speed Dial Access button, label an available button, enter
programming mode, and follow these steps:
1 Touch the button you want to program.
2 Dial *20.
3 Leave programming mode.
Local Conference, Drop, and Transfer Buttons
To program fixed feature buttons for use with the MERLIN II system only,
label the button(s), enter programming mode, and follow these steps:
1 Touch the button you want to program.
2 Dial the appropriate code:
Dial *96 for Local Conference
Dial *97 for Local Drop
Dial *99 for Local Transfer
3 Program another feature, or leave programming
mode.
2-22 MERLIN II System Features