Filter
Top Products
PROGRAMMING
To assign a consequential System Speed Dial code, touch [Enter] and
repeat steps 2 through 4.
6 Touch Conference to return to the administration menu, or leave
administration mode.
With a BIS-34D Console
1
2
3
4
5
6
7
8
9
Touch Conference.
The red light next to Adm Tel goes on.
Dial 0.
Dial a System Speed Dial code ( #60 to # 99).
If you are storing a marked Speed Dial code, dial * after dialing the
System Speed Dial code.
Dial the telephone number, including a leading 1 where required. If your
system is pooled with Dial Access, include the pool number on which the
call should be placed in the Speed Dial code.
NOTE: A number for a marked Speed Dial code can have up to 39
characters; a number for an unmarked Speed Dial code can have up to 40
characters. These characters can include a pause, a stop, a switchhook
flash, or Touch-Tone enable, mentioned above. It is best to include a
pause between the pool number and the telephone number (touch Hold)
when you administer a Speed Dial code that includes a pool number.
The display shows the telephone number, including any special
characters, as you dial it. If the number is not correct, perform the step
again.
Repeat steps 3 through 5 for each telephone number or account number to
which you are assigning a System Speed Dial code.
Touch Conference twice.
If you have a printer connected to your system, you can get a printout
of your System Speed Dial code numbers by touching Message and
dialing # 901.
All 40 codes (#60 through # 99) are printed out, even if some are not yet
assigned to telephone numbers,
If a number includes special characters,
they will appear as t for Touch-Tone enable, s for stop,
p for pause, or r
for recall.
Touch Message and go on to another procedure, or leave administration
mode.
To program a System Speed Dial code, label a button, enter programming
mode, and follow these steps:
1 Touch the button you want to program.
2 Dial *95 plus a 2-digit System Speed Dial code (60 through 99—do not
enter the “ # “)
3 Program another feature, or leave programming mode.
MERLIN II System Features
2-155