Filter
Top Products
Button Code Administration Procedures
Button code administration procedures are divided into two categories: basic
and optional procedures.
Basic Administration Procedures
Administration Procedure
Do This
System size
1 Touch Message.
2 Dial #201.
3
If green light next to
Message
is steady and you hear two beeps, go
on to step 4. If not, wait for 2-beep signal or try again later.
4 Dial number to designate system size:
o
= small system
1
= large system
5
Wait for lights next to
Adm Tel, Adm Pool, Message,
and
Speaker
to flash. At this signal, go to another procedure or leave
administration mode.
System type
1 Touch Message.
2 Dial #202.
3
If green light next to
Message
is steady and you hear two beeps, go
on to step 4. If not, wait for Z-beep signal or try again later.
4 Dial number to designate system type:
0 = square
1=
pooled with Button Access to Line Pools
2=
pooled with Dial Access to Line Pools
3 = pooled with Automatic Route Selection (ARS)
4 = behind-switch
5
Wait for lights next to
Adm Tel, Adm Pool, Message,
and
Speaker
to flash. At this signal, go to another procedure or leave
administration mode.
System Renumbering Procedure
1 Touch Message.
2 Dial #299.
If the light next to
Message
flashes by itself, one or more calls are in
progress and the procedure is not executed–wait for the light to
become steady, then go on to the next step.
3
When the lights next to
Adm Tel, Adm Pool, Message,
and
Speaker
begin to flash, go to another procedure or leave administration
mode,
3-2 Button Code Administration Procedures