Filter
Top Products
System components Page 51 of 466
Communication Server 1000E Installation and Commissioning
The TTY Settings are:
• Baud Rate: 9600
• Data bit: 8
• Stop bit: 1
•Parity: None
• Flow Control: None
CP PM Call Server Switch Settings
The CP PM Call Server switch S5 must be set to position 1 to indicate that a
CF card is used for the FMD.
The CP-PM Signaling Server switch S5 must be set to position 2 to indicate
that a hard disk is used for the FMD.
CP PM Call Server software
The CP PM Call Server software features the following enhancements for
CS 1000 Release 5.0:
• software is large-system based
• uses the same machine type (711) as CP PII and CP PIV
• new system type (4021)
• new High Availability package (410)
• new menus for setting the Side, Loop and Shelf information. The Loop
and Shelf refer to the IPMG Loop and Shelf where the CP PM CS is
located.