Filter
Top Products
Installing and configuring a Voice Gateway Media Card Page 319 of 466
Communication Server 1000E Installation and Commissioning
• Procedure 74: "Displaying the status of Voice Gateway Media Card
units" on page 341
• Procedure 75: "Displaying the status of one unit on a Voice Gateway
Media Card" on page 344
• Procedure 76: "Disabling a Voice Gateway Media Card using Element
Manager" on page 344
• Procedure 77: "Disabling a Voice Gateway Media Card unit using
Element Manager" on page 345
• Procedure 78: "Enabling a Voice Gateway Media Card using Element
Manager" on page 346
• Procedure 79: "Enabling a Voice Gateway Media Card unit using
Element Manager" on page 347
Configuring a card
A Voice Gateway Media Card requires configuration of:
• the IP telephony properties defined with Element Manager (the Voice
Gateway Media Cards are assigned to an IP telephony node). See
“Configuring an IP telephony node” on page 361.
• the voice gateway channels defined on the CS 1000E. See “Configuring
voice gateway channels using Element Manager” on page 323.
Adding a card to an IP telephony node
The Voice Gateway Media Card is added to an IP telephony node using
Element Manager only. See Element Manager: System Administration
(NN43001-632) for details.
Procedure 67
Adding a Voice Gateway Media Card to an IP telephony node
1 Log in to Element Manager.
2 Select IP Network > Nodes: Servers, Media Cards from the navigator.
The Node Configuration web page opens, as shown in Figure 127.