Installing and configuring a Voice Gateway Media Card Page 321 of 488
Communication Server 1000E Installation and Configuration
• Procedure 83: "Displaying the status of Voice Gateway Media Card
units" on page 344
• Procedure 84: "Displaying the status of one unit on a Voice Gateway
Media Card" on page 347
• Procedure 85: "Disabling a Voice Gateway Media Card using Element
Manager" on page 347
• Procedure 86: "Disabling a Voice Gateway Media Card unit using
Element Manager" on page 348
• Procedure 87: "Enabling a Voice Gateway Media Card using Element
Manager" on page 349
• Procedure 88: "Enabling a Voice Gateway Media Card unit using
Element Manager" on page 350
Configuring a card
A Voice Gateway Media Card requires configuration of:
• the IP telephony properties defined with Element Manager (the Voice
Gateway Media Cards are assigned to an IP telephony node). See
“Configuring an IP telephony node” on page 365.
• the voice gateway channels defined on the CS 1000E. See “Configuring
voice gateway channels using Element Manager” on page 325.
Adding a card to an IP telephony node
The Voice Gateway Media Card is added to an IP telephony node using
Element Manager only. See Element Manager: System Administration
(553-3001-332) for details.
Procedure 76
Adding a Voice Gateway Media Card to an IP telephony node
1 Log in to Element Manager.
2 Select IP Telephony > Nodes: Servers, Media Cards > Configuration
from the navigator.
The Node Configuration web page opens, as shown in Figure 99.
