Filter
Top Products
Installing a Signaling Server Page 225 of 466
Communication Server 1000E Installation and Commissioning
Figure 102
IP Telephony parameter configuration
• Proceed to step 16 on page 213.
• If this is a stand-alone Signaling Server and not associated with a
Call Server (that is, b was selected in step 11 on page 206), enter the
TLAN subnet parameters as required. The Call Server IP address is
automatically set to 0.0.0.0.
The IP information applies to a temporary IP Telephony node. This
ensures that the existing node is not impacted. This also preconfigures
the IP Telephony node files. In Signaling Server: Installation and
Commissioning (NN43001-312), the node files are imported to Element
Manager for further configuration.