Page 226 of 488 Configuring a Small System Controller
553-3041-210 Standard 4.00 September 2007
Configuring an SSC can involve:
1 Procedure 56: "Installing an SSC NTM400 Software daughterboard and
NTDK57 (NT_REM) remote security device" on page 227.
2 Procedure 57: "Adding a 100BaseT daughterboard (dual port) to an SSC"
on page 227
3 Procedure 58: "Adding a 100BaseT daughterboard (single port) to an
SSC" on page 231.
Adding a software daughterboard and
remote security device
A software daughterboard (NTM400) and a remote security device
(NTDK57) (NT_REM) must be installed on the SSC. Follow Procedure 56 to
install these required components.
Connectors • Port 1 – 100BaseT
• Port 2 – 100BaseT (optional)
• Port 3 – 100BaseT
• Port 4 – 100BaseT (optional)
Required
components
• Remote Security Device (NTDK57DA)
• Software daughterboard (NTM400)
Accessories • Flash daughterboard (NTTK25BA)
• 100BaseT daughterboard (single port)
(NTDK99AA)
• 100BaseT daughterboard (dual port)
(NTDK83AA)
Table 13
Small System Controller profile (Part 2 of 2)
Property Description
