Filter
Top Products
Page 386 of 466 Installing Line cards and cross-connecting telephones
NN43041-310 Standard 01.11 October 2008
Procedure 91
Connecting an off-premise telephone
1 Install the NTAK92BA Off-Premise Protection Module on the wall using
four #10 1/2-in (minimum) screws.
2 Connect a #6 AWG from the grounding lug at the bottom of the
NTAK92AA Off-Premise Protection Module to the system ground. Refer
to Figure 171 on page 387.
3 Connect two NTAK9204 cables (one from connector J1 and one from
connector J2) from the protection module to the cross-connect terminal.
4 Terminate the cables as shown in Figure 169 on page 383.
5 Cross-connect the J1 cable to the Tip and Ring connections coming from
the Line card.
6 Cross-connect the J2 cable to the off-premise telephone.
7 Install the regulatory label provided with the Off-Premise Protection
Module on the inside right-hand wall of the Media Gateway.
8 Install the Line card in its assigned position.
9 Activate the telephone.
DANGER OF ELECTRIC SHOCK
If connecting to a message-waiting Line card, unseat the
card from its assigned slot before continuing with the
next step.