Page 194 of 488 Installing and configuring the Signaling Server software
553-3041-210 Standard 4.00 September 2007
Figure 74
Installation Status Summary
17 Press <CR> to exit to the Main Menu (see Figure 56 on page 181). Enter
q at the Main Menu to quit the installation process. Figure 75 on page 195
appears. Enter q again.
---------------------------------------------------
INSTALLATION STATUS SUMMARY
---------------------------------------------------
+=================+========+========+==============================+
| Option | Choice | Status | Comment |
+=================+========+========+==============================+
| software | yes | ok | new install/upgrade x.xx.xx |
+-----------------+--------+--------+------------------------------+
| firmware | yes | ok | copy i2002 version 1.xx |
| firmware | yes | ok | copy i2004 version 1.xx |
+-----------------+--------+--------+------------------------------+
| loadware | yes | ok | copy IP Line x.xx.xx for P2 |
| loadware | yes | ok | copy IP Line x.xx.xx for SA |
+-----------------+--------+--------+------------------------------+
| configuration | yes | ok | set as Leader/Follower |
+-----------------+--------+--------+------------------------------+
Please press <CR> when ready ...
CS 1000 Signaling Server Software Install Tool (sse-x.xx.xx)
=====================================================================
| | | | version x.xx |
| firmware | yes | ok | copy PhaseII IP Firmware |
