Installing and configuring IP Phones Page 433 of 488
Communication Server 1000E Installation and Configuration
14 Enter the node number and the temporary or administrator IP Phone
Installer Password.
Note 1: An asterisk is displayed for each password digit entered; the
actual password is not displayed.
Note 2: If this screen times out, or if you do not successfully enter the
password in three attempts, the IP Phone continues its registration
process as if no entry had been made to this prompt. You can reboot the
telephone and try again if more tries are needed.
The IP Phone prompts:
TN: x.x
15 Enter the IP Phone’s (virtual) TN.
The IP Phone displays the logo, the date and time, and the DN keys.
16 Check for dial tone and the correct DN above the display.
End of Procedure
Using Set-Based Installation
Set-Based Installation enables the delegation of telephone installation to
trusted users. To have a trusted user perform this function, configure a
temporary IP Phone Installer Password for the system. See “Setting
administrator and temporary IP Telephone Installer passwords” on page 417.
Note: This feature can be an alternative to LD 11 or OTM to configure
IP Phones on the Call Server.
Follow Procedure 110 to use Set-Based Installation.
Procedure 110
Using Set-Based Installation
This procedure is the same as Procedure 107 on page 425, Procedure 108 on
page 428, and Procedure 109 on page 430, except when the system
response, displayed on the IP Phone, is as follows:
If you did not configure an IP Phone Installer Password, the IP Phone prompts:
