Filter
Top Products
Page 349 of 466
Communication Server 1000E Installation and Commissioning
360
Installing the Main Distribution Frame
Contents
This section contains information on the following topics:
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 349
Terminal block requirements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 350
Installing a BIX cross-connect terminal . . . . . . . . . . . . . . . . . . . . . . . . 350
Installing a Krone Test Jack Frame for the UK . . . . . . . . . . . . . . . . . . 352
Connecting the cables to the Media Gateways . . . . . . . . . . . . . . . . . . . 356
Introduction
This chapter describes how to install and connect a CS 1000E system using
the BIX, or Krone Test Jack Frame (UK) cross-connect terminals.
This chapter contains the following procedures:
1 Procedure 80: “Installing a BIX cross-connect terminal” on page 350.
2 Procedure 81: “Installing the Krone Test Jack Frame (UK)” on page 354.
3 Procedure 82: “Connecting the cables to the Media Gateways” on
page 356.
Note: The use of the BIX system is not mandatory; however, it is the
recommended option.