Filter
Top Products
Configuring a terminal and SDI ports Page 281 of 466
Communication Server 1000E Installation and Commissioning
Figure 121
VT220 setup values
CS 1000E CP PM Call Server COM Port connections
There are 2 serial ports on the CP PM Call Server, Port 0 and Port 1. They are
accessed through a special cable that attaches to the MDF port at the back of
the cabinet. Both ports are standard RS232 DTE ports. The supported TTY
settings for both ports are:
• Baud rate - 9600
• Data bit - 8
• Stop bit - 1
Global Set-Up
On Line Comm1=RS232
Sessions on Comm1 70Hz
CRT Saver Printer Shared
Display Set-Up
80 Columns Light Text, Dark Screen
Interpret Controls Cursor
Auto Wrap Block Style Cursor
Jump Scroll
General Set-up
VT200 Mode, 7-bit Controls Application Keypad
User Defined Keys Unlocked Normal Cursor Keys
User Features Unlocked No New Line
Multinational
Communications Set-Up
Transmit=2400 No Local Echo
Receive=Transmit Data Leads Only
Xoff at 64 Disconnect, 2 s Delay
8bits, No Parity Limited Transmit
1 Stop Bit
Printer Set-Up
Speed=9600
Normal Print Mode Print Full Page
8bits, No Parity, Print National Only
1 Stop bit No Terminator
Keyboard Set-up
Typewriter Keys Warning Bell
Caps Lock Break
Auto Repeat Answerback=
Keyclick High Not Concealed
Margin Bell
Tab Set-Up Screen
Leave this screen at the default values