Filter
Top Products
Page 118 of 466 Installing software on the CS 1000E
NN43041-310 Standard 01.11 October 2008
Installing the software
This section provides the steps involved in installing CS 1000 Release 5.0 for
CP PM.
Procedure 18
Installing the software on the CP PM Call Server
1 Connect the terminal to port 0 with the NTAK19EC cable.
2 Insert the CF card into the Call Server faceplate.
3 Reboot the card by pressing the RST button on the faceplate of the Call
Server. When prompted (see Figure 31), enter F to “force board to boot
from faceplate drive” (prompt may appear twice).
Figure 31
Upgrade boot sequence
IMPORTANT!
Systems and components delivered to customer sites
may include preinstalled software. However, the
pre-installed software versions are typically older and are
included only for manufacturing and order management
purposes. Do not attempt to operate the system with
the pre-installed software. You must download the
latest software from the Nortel Software Download web
site and install the software as part of the installation
process.