Page 270 of 488 Configuring a terminal and SDI ports
553-3041-210 Standard 4.00 September 2007
• Parity - none
• Flow control - none
MG 1000E SDI connection
SDI connection to the MG 1000E is made at the back. See Figure 88 on
page 272 for location of the 9-pin DTE (male) connector. It is modified to
isolate pins 6, 7, and 8. Use PORT0 of NTBK48AA 3-port SDI cable for
terminal connection.
Note: Connection must be made initially to each MG 1000E to set the
IP address.
MG 1000T SDI connection
A terminal, modem, or other device (such as CDR devices and additional
TTYs) can be connected to the SDI ports. Follow Procedure 69 on page 272
to connect devices to Media Gateways.
Refer to Table 18 for SDI port numbering for MG 1000T Core and
MG 1000T Expansions.
Table 18
SDI port numbering for Media Gateways
Media Gateway Normal mode Survival mode
MG 1000T Core 0, 1, 2 N/A
MG 1000T Expansion 1 3, 4, 5 0, 1, 2
MG 1000T Expansion 2 6, 7, 8 0, 1, 2
MG 1000T Expansion 3 9, 10, 11 0, 1, 2
MG 1000T Expansion 4 12, 13, 14 0, 1, 2
