Filter
Top Products
Installing and configuring a Voice Gateway Media Card Page 331 of 466
Communication Server 1000E Installation and Commissioning
4 Insert the CompactFlash card in the socket.
Press firmly until it is fully seated and the Eject button extends (see
Figure 137).
Figure 137
Insert CompactFlash to extend Eject button
5 Turn the Voice Gateway Media Card over to view the back of the card.
Identify the hole for the Retaining Pin. The hole (labeled a in Figure 138)
is located approximately 1 inch (2.5 cm) above the lower lock latch and
1 inch (2.5 cm) from the card’s faceplate.
Figure 138
Retaining Pin hole
6 Insert the Retaining Pin in this hole (labeled 1 in Figure 139).
Eject button