Filter
Top Products
Page 464 of 466 Configuring IP Peer Networking and managing the Gatekeeper database
NN43041-310 Standard 01.11 October 2008
You must configure the following data when setting up a CS 1000E
IP network:
1 Configure the Virtual Trunk routes using Element Manager or the
Command Line Interface (LD 16). Configure the Route Data Blocks and
associate the Virtual Trunk routes with the IP network by configuring the
following parameters:
a route information
b network management information
(for example, Access Restrictions)
c bandwidth zone
d Signaling Server host name for the route
e protocol identifier
f associated Node ID
2 Configure the Virtual Trunks using Element Manager or the Command
Line Interface (LD 14).
3 Configure the network routing within the CS 1000E.
a Use existing tools to configure networking features, such as routing
calls based on digits dialed.
b Configure dialing plan information for calls that must be routed to
circuit-switched trunks (for example, PSTN interfaces). You can
route these calls using a feature such as Network Alternate Route
Selection (NARS). Configure Virtual Trunk routes in NARS the
same way as traditional trunks.
4 Configure the Primary, Alternate, and Failsafe Gatekeepers at
installation and initial setup.