Filter
Top Products
Page 430 of 466 Installing and configuring Nortel IP Phones
NN43041-310 Standard 01.11 October 2008
14 Enter the node number and the temporary or administrator Nortel IP
Phone Installer Password.
Note 1: An asterisk is displayed for each password digit entered; the
actual password is not displayed.
Note 2: If this screen times out, or if you do not successfully enter the
password in three attempts, the Nortel IP Phone continues its registration
process as if no entry had been made to this prompt. You can reboot the
telephone and try again if more tries are needed.
The Nortel IP Phone prompts:
TN: x.x
15 Enter the Nortel IP Phone’s (virtual) TN.
The Nortel IP Phone displays the logo, the date and time, and the DN
keys.
16 Check for dial tone and the correct DN above the display.
End of Procedure
Using Set-Based Installation
Set-Based Installation enables the delegation of telephone installation to
trusted users. To have a trusted user perform this function, configure a
temporary Nortel IP Phone Installer Password for the system. See “Setting
administrator and temporary IP Telephone Installer passwords” on page 414.
Note: This feature can be an alternative to LD 11 or TM to configure
IP Phones on the Call Server.
Follow Procedure 101 to use Set-Based Installation.
Procedure 101
Using Set-Based Installation
This procedure is the same as Procedure 98 on page 422, Procedure 99 on
page 425, and Procedure 100 on page 427, except when the system
response, displayed on the Nortel IP Phone, is as follows:
If you did not configure an Nortel IP Phone Installer Password, the Nortel IP
Phone prompts: