Filter
Top Products
Connecting an MRV LX8020S-102AC-R Terminal Server Page 275 of 466
Communication Server 1000E Installation and Commissioning
InReach:0>>configure rlogin enable.
4 Configure the rlogin port for various applications.
InReach: 0>> config port async xx connect command rlogin
-l user_name host_ip_address
InReach: 0 >>config port async 1 connect command rlogin -l
pty8 47.11.244.101
Here PTY8 is the user name.It is the port no. used while configuring the PTY.
It has to be configured in overlay 17 of the switch
5 To bring up a connection from the LX to some device on LAN
InReach: 0>> config port async xx access local
6 To build up the autoconnection to a specified IP client
InReach:0>>config port async n connect command telnet
n.n.n.n
where n = the port number you are configuring, and n.n.n.n = the IP
address of the host
7 Prevent authentication inbound or outbound. These commands disable
authentication on the LX port which would prevent the ability to make a
connection without intervention.
InReach:0>>config port async n no authentication outbound
InReach:0>>config port async n no authentication inbound
8 To avoid autohangup:
InReach:0 >>config port async <nn> no autohangup
Here are the commands you would perform on an IR to do the same thing;
Note: DEFINE/SET PORT port-list AUTOCONNECT ENABLED
DEFINE/SET PORT port-list AUTOHANGUP DISABLED
9 Enable the transparency mode and save the configuration information.
InReach:0>> config port async xx no telnet negotiation
InReach:0>> config port async xx transparency enable
InReach:0>> config port async xx flowcontrol cts
InReach:0 >>save config flash