Filter
Top Products
Configuring the CS 1000E CP PM Call Server Page 161 of 466
Communication Server 1000E Installation and Commissioning
Configuring the MG 1000E Bandwidth Management Zones
Follow Procedure 34 for configuring bandwidth management zones.
Procedure 34
Configuring MG 1000E Bandwidth Management Zone
1 Enter LD 117 and press <cr>.
2 Enter NEW ZONE 0, to create a new zone with default parameters.
Note: LD 117 also includes DIS and ENL commands to disable or enable
a zone. When you create a zone, its default state is enabled. See LD 117
– Bandwidth management zone commands on page 162.
3 Print zone and bandwidth information using PRT INTRAZONE or PRT
INTERZONE.
4 Exit from LD 117 by entering the command: ****