Filter
Top Products
Page 346 of 466 Installing and configuring a Voice Gateway Media Card
NN43041-310 Standard 01.11 October 2008
The Network and Peripheral Diagnostics web page opens, as shown in
Figure 149 on page 343.
4 Select the DISU – Disable unit command from the Unit Commands
drop-down list.
5 Enter the card number and unit number in the corresponding Command
Parameter text box.
6 Click Submit to the right of the text box.
The output from this command is shown in the text box in the lower half
of the web page.
End of Procedure
Enabling a card
Follow Procedure 78 to enable a Voice Gateway Media Card using
Element Manager.
Procedure 78
Enabling a Voice Gateway Media Card using Element Manager
1 Select System > Maintenance from the navigator.
The Maintenance web page opens as shown in Figure 147 on page 341.
This page allows you to perform maintenance using overlays or using a
selected functionality. The default is overlay, as shown in Figure 147.
2 Select Select by Functionality.
The list in the web page changes to show a list of diagnostics you can use,
as shown in Figure 148 on page 342.
3 Select Network & Peripheral Equipment Diagnostics from the list in
Figure 148 on page 342.
The Network and Peripheral Diagnostics web page opens, as shown in
Figure 149 on page 343.
4 Select the ENLC – Enable and reset card command from the Card
Commands drop-down list.
5 Enter the card number in the corresponding Command Parameter text
box.
6 Click Submit to the right of the text box.