A SERVICE OF

logo

Configuring the CS 1000E Call Server Page 211 of 488
Communication Server 1000E Installation and Configuration
Configuring the MG 1000E Bandwidth Management Zones
Follow Procedure 52 for configuring bandwidth management zones.
Procedure 52
Configuring MG 1000E Bandwidth Management Zone
1 Enter LD 117 and press <cr>.
2 Enter NEW ZONE 0, to create a new zone with default parameters.
Note: LD 117 also includes DIS and ENL commands to disable or enable
a zone. When you create a zone, its default state is enabled. See LD 117
– Bandwidth management zone commands on page 212.
3 Print zone and bandwidth information using PRT INTRAZONE or PRT
INTERZONE.
4 Exit from LD 117 by entering the command: ****