Filter
Top Products
Installing and cross-connecting a trunk card Page 293 of 466
Communication Server 1000E Installation and Commissioning
Note: See “Installing and cross-connecting a Power Fail Transfer Unit”
on page 437 for connecting trunks with the PFTU.
End of Procedure
Universal Trunk card connections
The Universal Trunk card (NT8D14) provides eight Analog trunks that can
function in the modes identified in Table 24. Refer to Table 25 on page 294
for the connections to the Universal trunk at the cross-connect terminal.
Table 24
NT8D14 Universal Trunk card – modes and option settings
Modes Location Jumper strap
Central (CO) J1, J2 OFF
2-way TIE trunk (loop Dial Repeat) J1, J2 OFF
2-way TIE trunk (Outgoing Incoming
Dial)
J1, J2 OFF
Recorded Announcement (RAN) J1, J2 OFF
Paging trunk J1, J2 OFF
Japan CO/DID operation J1, J2 OFF
DID operation
Loop length>2000 ohms
J1, J2 ON
DID operation
Loop length <2000 ohms
J1, J2 OFF
Note 1: OFF indicates that no strap is present.
Note 2: J1 and J2 locations apply to all eight trunks.