Installing and configuring IP Phones Page 424 of 488
Communication Server 1000E Installation and Configuration
Configuring the IP Phone boot parameters
The IP Phone boot parameters are configured during telephone installation.
The following configuration modes are available:
• Manual configuration
— All of the IP Phone's boot parameters are statically configured at the
IP Phone.
— See Procedure 107: "Entering IP Telephone boot parameters using
manual configuration" on page 425.
• Partial Dynamic Host Configuration Protocol (DHCP) mode
— Works with standard DHCP server. The DHCP server automatically
provides the IP Phone with an IP address; the remainder of the IP
Phone's boot parameters are statically configured at the IP Phone.
— See Procedure 108: "Entering IP Phone boot parameters using full
DHCP parameters" on page 428.
• Full DHCP mode
— Requires special configuration of the DHCP server to recognize the
IP Phone. The DHCP server provides all boot parameters to the IP
Phone, including IP address and server address.
— See Procedure 109: "Entering IP Phone boot parameters using
partial DHCP parameters" on page 430.
For configuration of the DHCP server, see Converging the Data Network with
VoIP (553-3001-160).
