Installing and configuring IP Phones Page 427 of 488
Communication Server 1000E Installation and Configuration
b. Enter 1 to configure manual VLAN.
The IP Phone prompts:
VLAN: x
Go to step 14 on page 427.
c. Press the OK key.
The IP Phone prompts:
Invalid TN: x.x
Reason: Unequipped.
Go offhook to do SBI
14 Enter the VLAN ID.
The IP Phone displays:
Locating server...
If you did not configure an IP Phone Installer Password, after several
seconds, the IP Phone prompts:
Node: x
TN: x.x
15 Enter the node number and the IP Phone's (virtual) TN, then go to Step
18.
If you configured an IP Phone Installer Password, the IP Phone prompts:
Node: x
PassWord: x
16 Enter the node number and the temporary or administrator IP Phone
Installer Password.
Note 1: An asterisk is displayed for each password digit entered; the
actual password is not displayed.
Note 2: If this screen times out, or if you do not successfully enter the
password in three attempts, the IP Phone continues its registration
process as if no entry had been made to this prompt. You can reboot the
telephone and try again if more tries are needed.
The IP Phone prompts:
TN: x.x
