Page 188 of 488 Installing and configuring the Signaling Server software
553-3041-210 Standard 4.00 September 2007
Figure 65
Network Routing Service (NRS) — stand-alone Signaling Server
12 Select the type of NRS to be provided by this Signaling Server. See
Figure 66 for a co-resident Signaling Server. See Figure 67 on page 189
for a stand-alone Signaling Server.
• If this Signaling Server is to be the Primary NRS, enter a.
• If this Signaling Server is to be the Alternate NRS, enter b.
• If this Signaling Server is not a stand-alone Signaling Server and is
to be the Failsafe NRS, enter c.
Refer to IP Peer Networking: Installation and Configuration
(553-3001-213) for more information on the NRS.
Figure 66
NRS type — co-resident Signaling Server
CS 1000 Signaling Server Software Install Tool (sse-x.xx.xx)
=====================================================================
Please select the Network Routing Service (NRS) configuration for this
Signaling Server.
Please enter:
<CR> -> <a> - H.323 Gatekeeper and SIP Redirect/Proxy Server.
<b> - H.323 Gatekeeper only.
<c> - SIP Redirect/Proxy Server only.
Enter Choice>
CS 1000 Signaling Server Software Install Tool (sse-x.xx.xx)
=====================================================================
Please select the type of Network Routing Service (NRS) for this
Signaling Server.
Please enter:
<CR> -> <a> - Primary.
<b> - Alternate.
<c> - Failsafe.
Enter Choice>
