Filter
Top Products
Configuring an IP telephony node Page 371 of 466
Communication Server 1000E Installation and Commissioning
Note 1: Clicking Transfer / Status displays the Transfer / Status web
page (see Figure 165 on page 373). This sends the node configuration
files to all IP Telephony components in the node.
• If any element within the node fails to transfer either BOOTP or
CONFIG files, Transfer / Status is highlighted in red.
• Transfer / Status is highlighted in yellow if the transfer status of the
node elements is unavailable.
Note 2: Delete is used to delete the corresponding node. The node is not
automatically deleted. A message displays and asks if you are sure you
want to delete the node.
2 Review the node parameters by opening each tab.
Note: For detailed information on each of the node parameters, refer to
IP Line: Description, Installation, and Operation (NN43100-500).
3 Click Save and Transfer.
4 Click OK to save the node configuration to the CS 1000E and transfer the
configuration to all elements.
After a few seconds, the Transfer Progress web page opens and
displays each of the elements in the node (see Figure 162 on page 372).
The Voice Gateway Media Cards retrieve the CONFIG.INI and
BOOTP.TAB files from the CS 1000E. A check mark is added to each
field as the card receives its CONFIG.INI and BOOTP.TAB files.
The status column provides the progress of the transfer:
• The Status column displays “Starting” as the transfer begins (see
Figure 162 on page 372).
• The Status column displays “Transfer” as the node configuration is
transferred to the elements (see Figure 163 on page 372).
• The Status column displays “Complete” if the transfer is successful
for an element (see Figure 164 on page 373).
• The Status column displays “Fail” if the transfer is unsuccessful.