Configuring the CS 1000E Call Server Page 215 of 488
Communication Server 1000E Installation and Configuration
superloop of the MG 1000E. The first MG 1000E in the superloop is on shelf
0, and the second MG 1000E’s on shelf 1. Sixteen units of DTMF tone
detection (DTR) are integrated within the controller (SSC) circuitry, or eight
Digitone Receiver units can be configured on each of card 14 and card 15.
These Digitone Receiver units are built in on the SSC card in the MG 1000E.
No additional hardware is required. If Digitone Receivers units are
configured in any other card slots, a receiver hardware pack must be equipped
in the slot. If no hardware is equipped, the unequipped receiver units may be
allocated during call processing, resulting in call failure.
Any additional tone signaling resources must be added and configured as IPE
cards.
Configure Digitone Receivers in LD 13.
Configuring Tone Detectors
Tone Detectors, when required, are configured in a manner similar to that for
Digitone Receivers. The SSC card in the MG 1000E provides four units of
Multifrequency Senders and Receivers. These units are configured on card 15
LD 13 – Configure the Digitone Receivers
Prompt Response Comment
REQ NEW CHG Add or change the existing data.
TYPE a...a Type of data block (a...a = DTR, MFC, MFE, MFK5, MFK6,
or MFR)
TN l s c u Terminal Number
l = loop for CS 1000E system. MG 1000E requiring Digitone
Receivers.
s = 0 or 1
c = 14 or 15 to access the integrated MG 1000E tone
circuits
u = 0-7 DTMF detectors (DTR)
0-3
MFR, MFC, MFE, MFK5, MFK6 units on card 15
