Page 236 of 488 Installing software on an MG 1000E Small System Controller
553-3041-210 Standard 4.00 September 2007
Installing software on an MG 1000E SSC
The MG 1000E is shipped with a pre-programmed software daughterboard
that must be mounted on the SSC.
Procedure 59
Installing software on an MG 1000E SSC
1 Confirm that the outlet is providing the correct voltage. Refer to the label
at the back of the equipment.
2 Connect the power cord from the power connectors at the back of the
MG 1000E to an AC power source.
3 Ensure that the system terminal (TTY) is connected to the cable marked
“port 0” on the NTBK48 3-port cable of the Media Gateway.
4 Turn the Media Gateway power switch to “ON”.
System response:
Current system time and date :
2/14/2096 6:19:00
Enter new time (hh:mm:ss) : 14:41:00
Enter new date (mm/dd/yy) : 06/03/04
14:41:0 -- 6/3/2004 is the new system time and date.
Is this correct? (y/n/[a]bort) : y
q]uit, [h]elp or [?], <cr> - redisplay
IMPORTANT!
Before proceeding, ensure that the required hardware is correctly
installed and that all connections are secure.
