Panasonic MINAS A5 Two-Way Radio User Manual


 
2-106
For parameters which place is displayed
with “ ”, the content changed and
written to EEPROM becomes valid after
turning off the power once.
'LVSOD\WKH1RRISDUDPHWHUWREH
changed and press to change to
(;(&87,21GLVSOD\
3UHVVDQGWKHIODVKLQJGHFLPDO
separator shifts to the high order position,
allowing the figure at this digit to any other
figure.
(SET button)
3UHVVRUWRVHWXSWKHYDOXHRI
parameter. (Value increases with
decreases with .)
3UHVVDQGWKHIODVKLQJGHFLPDO
separator shifts to the high order position,
allowing the figure at this digit to any other
figure.
3URORQJHGGHSUHVVLRQRIXSGDWHVWKH
SDUDPHWHULQWKHGULYHU1RWHWKDWWKH
parameter value selected by or is
not reflected until is pressed in this
way.
7RFDQFHOWKHYDOXHVHOHFWHGE\RU
press instead of , and the driver
internal parameter value is kept
unchanged and the display returns to the
parameter number display screen.
After changing the parameter value and
pressing , the content will be reflected in
the control.
'RQRWH[WUHPHO\FKDQJHWKH
parameter value which change might affect the
motor movement very much
(especially
velocity loop or position loop gains).
(Mode switch button)
(Mode switch button)
Pr0.00
Pr0.00
Pr0.01
Pr6.32
Pr0.01
Pr6.33
3UHVVRUWRVHOHFWSDUDPHWHU1R
to be set.
3DUDPHWHU1R
+H[DGHFLPDO1R
Parameter value
Class
Pr0.11
Pr1.11
You can change the
value which digit has
a flashing decimal
point.
SELECTION display
Monitor Mode
SELECTION display
Parameter Setup Mode
SELECTION display
EEPROM Writing Mode
EXECUTION display
Remarks
Note
Note
$IWHUVHWWLQJXSSDUDPHWHUVUHWXUQWR6(/(&7PRGHUHIHUULQJWRVWUXFWXUHRIHDFKPRGH
(P.2-88).
(DFKSDUDPHWHUKDVDOLPLWLQQXPEHURISODFHVIRUXSSHUVKLIWLQJ
2
Preparation
15. How to Use the Front Panel
Parameter Setup Mode